Small Ironing Board Cover

Here’s a technique for sewing a Slide-Out Ironing Board cover that won’t interfere with the drawer mechanism. (Click here to learn how to make your own Slide-Out Ironing Board.)

Tips:

1) I’m using a layer of heat-reflecting fabric underneath my cotton cover. This helps heat to radiate from underneath the fabric as well as from the iron above.  You can buy it from JoAnn’s fabric, it’s found by the upholstery fabrics.

How to:

1
You should already have traced your slide-out ironing board onto a piece of wrapping paper. Now we’ll enlarge the template by adding a 1/2 inch to each of the long sides. The two short ends will need an extra 2 1/2 inches, plus the height of your board. For me, that means I’ll be adding 3 1/2 inches to the short ends.

2
I’m using a layer of heat-reflecting fabric underneath my cotton cover. This helps heat to radiate from underneath the fabric as well as from the iron above.  You can buy it from JoAnn’s fabric, it’s found by the upholstery fabrics. Make sure your fabrics are free of wrinkles, then lay both fabrics face up on the table, with the cotton on top. Pin the pattern in place and cut out.

3
Turn the fabrics face down. Fold the raw edge under 1/4 inch, then fold another 1/4 inch to encase the raw edge. Press and pin, all the way around. Lay the fabric on top of your board to check the fit. The edges on the two long sides should cover the wood, but not overlap the metal slides.

4
Sew in place with a 1/8 inch seam.

5
Pin the fuzzy side of the sew-on Velcro to the wrong side of t he back straight edge. Sew in place using a zig-zag stitch.

6
Lay the fabric face down on the table. Press a rough piece of adhesive Velcro onto the  strip you just sewed. Lay the ironing board on top and fold up the edge, pressing the sticky Velcro in place.

7
Flip the ironing board over so you can position the fabric in front. With the back still Velcroed in place, pull the fabric taut. Fold it under and around the slanted edges, like you’re wrapping a present. Tuck the fabric on one corner so it has a nice sharp edge, then place a pin through this pleat. Remove cover and sew through the pleat with a straight stitch.

8
Velcro the back in place once more, and replace the fabric at front. Now create a pleat on the other side.

9
We’ll use the opposite pieces of Velcro for the front, so we won’t have unmatched Velcro left over. Sew the rough side of the Velcro to the front and angled portions of the fabric using a zig-zag stitch.

10
Add the fuzzy adhesive Velcro on top, then fold over to the bottom of the board and press firmly in place.

Made By Marzipan may have received product or payment for this post. Posts may contain affiliate links. Disclosed in accordance with the Federal Trade Commission's 16 CFR, Part 255.

Leave a Reply

Your email address will not be published.