Reversible Frozen Cape

Do you know a little girl who loves the movie Frozen? Sew her a reversible cape so she can pretend to be Anna or Elsa!

How to:

1
Begin by cutting a piece of blue costume satin, a piece of maroon costume satin, and a piece of shimmery white organza to 38 x 27 inches.

2
I’m choosing to have the non-shiny side of my maroon satin to be the outside, since Anna’s cape isn’t shiny in the movie. Place the two satins right-sides together and pin.

3
Sew the long sides and bottom with a ½ inch seam, stopping about 3 inches from the top short edge. (When sewing with light fabrics like satin, it’s best to use a Microtex sharp needle.) Trim the corners and turn right side out.

4
Now we’ll make the casing that will hold the elastic at the neck. This will make it easy for the child to put on and remove the cape by themselves.

Cut a piece of blue satin and a piece of maroon satin to 8 x 3 inches. Place right-sides together and sew the long sides with a  ¼ inch seam. Turn right side out.

5
Tuck one end of the tube between the cape layers, leaving about ½ inch of excess cape fabric at top. Fold in the raw edges on the side of the cape and pin the tube in place.

6
Stitch along the side of the cape, tacking down the tube with stitches at the top and bottom. Leave a ½ inch hole in the center of the tube so you can thread the elastic through later. Use maroon thread up top and blue in your bobbin.

7
Now we need to make the casing on the cape itself. Topstitch the width of the cape, aligning the row of stitches with the bottom of the tube piece.

8
Next we’ll sew the organza layer, which will go over the blue Elsa cape. Double-fold the raw edges of the sides and bottom and sew with a ¼ inch seam. You can leave the top edge unsewn.

9
Layer the organza on top of the blue satin. Fold in the raw edges of all three fabric layers, aligning them evenly at top. Pin and sew with a ⅛ inch seam.

10
Finally, we will make the cowl piece that will go on the maroon Anna cape. Fold a 27 x 16 inch piece of maroon satin in half lengthwise. Place a plate along the fold, then trace the curve with a piece of chalk. Fold the fabric in half width-wise so the both short ends of the rectangle are layered. Pin together and cut around the curve.

11
Unfold the fabric and cut down the middle. Pin pom-pom trim to the right side of one cowl piece. The pom-poms should point inward. Make sure your pins extend outward for easy removal while sewing. Add the trim along the curves and the long bottom piece, but not around the top.

12
Layer the other cowl piece face-down on the first. Pin together. Sew around the edge with a ¼ inch seam, leaving a 4-inch opening for turning along the top.

13
Turn right side out. Fold in the raw edges of the hole. Topstitch shut with a  ⅛ inch seam, then continue topstitching all the way around.

14
Lay the cowl piece on top of the maroon cape. Line up the top edge. Pin together. Sew with a 1/4 inch seam, with maroon thread up top and blue in your bobbin.

15
Lastly, we need to add the elastic. Clip a safety pin to the end of elastic that is ½ inch wide. Thread it through the tube piece and cape casing. Pull to gather until it’s a good size for your child. You want it to be loose enough that they can easily pull it over their head, but not loose enough to slide down their shoulders.

16
Join the elastic with a zig-zag stitch, backstitching for durability.

17
Finally, slide the loose end of the tube into the side of the cape. Fold in the raw edges, then topstitch with a ⅛ in. seam. Continue topstitching around the sides and bottom of the cape, keeping the blue organza layer out of the way.

Little girls will love pretending to be their favorite Disney characters!

Made By Marzipan may have received product or payment for this post. Posts may contain affiliate links. Disclosed in accordance with the Federal Trade Commission's 16 CFR, Part 255.

5 thoughts on “Reversible Frozen Cape

  1. Beth says

    Hi! I’m LOVE this cape and am trying to make it for my daughter. But, I’m having trouble with the pompom trim. I bought 1 yard, but it doesn’t seem to be enough. I can make it work by bringing the side curves in a bit (about 1-2″ each side). Do you think this will affect the end result?
    Thanks!!

    • says

      Hi Beth! Just to check, you’re only putting the pom-pom trim along one edge, right? It doesn’t go the entire way around the collar. But this is such a basic project that it’s flexible, you can certainly bring in the curves if you need to :)

  2. Beth says

    Thank you! It came out great!! It was a bit big for my daughter once she tried it on, so I brought the elastic way in at the neck and took the length up a few inches. SO CUTE!!

  3. Nola says

    Here’s a different idea for the neck closure. I like the elastic, but when I make capes I have an opening in front and sew on magnets (available at fabric stores in notions area) to close the neck. That way they can’t choke if it gets caught on something.

    • says

      Great idea, Nola! Thanks for sharing!

Leave a Reply to Beth Cancel reply

Your email address will not be published.